收录:
摘要:
In this paper, a composite technique of ELID grinding and mechanical polishing is used for ultra-precision maching experimental research. First, ELID grinding is adopted to pre-process the surface of WC-Co cemented carbide, obtaining the precision machined surface Ra 18nm, then the mechanical polishing process is implemented. When conducting mechanical polishing, the speed of the turntable is set to 150 ∼200 r/min, and the polishing perssure is controlled in 0.2 ∼0.5 N/cm2, the polishing liquid containing W1 diamond grits is used to process the surface for about 100 minutes, aiming to achieve a rapid removal. Then using the polishing liquid containing W0.5 diamond grits for another 100 minutes, an ultra-percision Ra4 nm is obtained by the mechanical polishing method. Meanwhile, the influence factors of the surface roughness during mechanical polishing process were tested, such as abrasive type, grain size, polishing liquid solvents, polishing persure, polishing time, etc.
关键词:
通讯作者信息:
电子邮件地址:
来源 :
Diamond and Abrasives Engineering
ISSN: 1006-852X
年份: 2010
期: 5
页码: 11-14,20